Cadence Q DRIVE SERIES Guide d'installation télécharger pdf (Page 6)

10 11

Install any combination of speakers independently on all 4 channels being careful not

to load any single channel below 2 ohm stereo. For typical 6” x 9” or 6.5” or component

speaker installs, set the Crossover Mode Switch to Full Range.

When bridging the four channel amplier, make sure that your nal woofer impedance on each bridged

channel is no lower than 4 ohms. Set the Crossover Mode Switch to Low Pass and begin by setting the

crossover frequency control to 100Hz and tuning from there. The dashboard bass remote control works only

on channels set to Low Pass.

Basic 4 Channel Configuration 4 Channel Amplifier Bridged to 2 Channels

CROSSOVER MODES SWITCH IN

FULL RANGE POSITION

LEFT SPEAKER

2-4 OHM

RIGHT SPEAKER

2-4 OHM

LEFT SPEAKER

2-4 OHM

RIGHT SPEAKER

2-4 OHM

CH 1-2

CROSSOVER MODE SWITCH

IN LOW PASS POSITION

CH 3-4

CROSSOVER MODE SWITCH

IN LOW PASS POSITION

RIGHT SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

LEFT SUBWOOFER

MINIMUM IMPEDANCE

4 OHMS

FRONT SPEAKERS

REMOTE SUBWOOFER

LEVEL CONTROL

REAR SPEAKERS

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Pas de commentaire

Cadence Q DRIVE SERIES Guide d'installation Page 6